LI-PO BATTERY 7.4V - 600 MAH FOR AEP

Specifications

Nominal voltage: 7.4 V (2 cells in series)

Capacity: 600 mAh

Maximum indicated charging current: 0.6 A

Dimensions: 85 × 25 × 12 mm

Weight: 330 g

Associated hazards and risks

Deep discharge (below ~ 3.0 V/cell) – can irreparably degrade the battery or make it unusable.

Overcharge (above ~ 4.2 V/cell) – risk of swelling, leakage, fire or explosion.

Excessive charging current – ​​if what the battery can withstand is exceeded, overheating occurs.

Puncture, impact or deformation – any physical damage can compromise the cells or insulation, leading to an internal short circuit.

Exposure to extreme temperatures – high temperatures can lead to fire or explosion; very low temperatures affect performance and can damage the battery if it is charged then.

Unattended charging – there is a risk of fire if the battery is charged unattended, especially if safety equipment is not used (fireproof bag, suitable charger).

Improper storage – keeping the battery connected to the replica when not in use, or left completely discharged, can lead to permanent damage.

Safety recommendations

Only use Li-Po chargers with balancing to ensure that all cells are charged evenly and to avoid overcharging.

Disconnect the battery from the replica immediately after use to prevent parasitic discharge.

Charge the battery under supervision and, preferably, in a fireproof Li-Po bag, on a non-flammable surface.

Store it at an intermediate charge level when not in use (≈ 3.8 V/cell) and keep it in a cool place away from heat sources.

Do not use the battery if you notice any signs of damage: swelling, deformation, unusual odor, or excessive heating.